Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Chamberlain openers
Before
After
Before
After
Before
AfterGarage Door Before & After in Long Beach, CA
Photos are the only proof that matters when you’re choosing a garage door company. We can tell you about our 18,000+ completed jobs since 2015, but showing you a cracked panel next to a clean new one tells the story faster. Every project below follows the same Haven Standard rules: a written price before work starts, a documented photo record when we leave, and a door that works. This is what leaving looks like.
Recent Transformations
Torsion Spring Replacement in Belmont Shore
A torsion spring on this Belmont Shore garage door snapped at 6:40 a.m. on a Tuesday. The cable had whipped loose and the door was wedged three feet off the ground, so nothing in that garage was secure. We measured the old spring at 0.250-inch wire diameter with a clean break at the coil, matched it to the door’s weight, and had the new spring in before the owner’s first meeting. The photo record showed the snapped spring removed, the new spring torqued, and the door running level. That same spring now has a written warranty and a 365-Day Done Right Promise behind it.
Panel Replacement After a Run-In With a Bumper on Junipero Avenue
A car nudged the bottom panel of a Junipero Avenue garage door hard enough to buckle it, but the rest of the door was fine. Replacing the entire door would have been wasteful, so we sourced a matching panel for the existing Clopay model and swapped just the damaged section. The before photo showed the buckled panel and the bent lower track. The after photo showed the new panel matched in color and grain, with the door cycling quietly. The homeowner kept the whole bill under a third of what a new door would have cost.
Full Door Replacement for a 22-Year-Old Wood Door in Los Altos
This Los Altos home had a 22-year-old wood door that had warped enough to leave a visible gap at the bottom corner. Skunks and June gloom air were both getting in. We removed the old door, rails, and hardware, then installed an insulated steel door sized to the same opening. The before photo documented the rotted bottom rail and the gap. The after photo showed the new door sealed tight with weatherstripping against the floor. The owner got the written scope and flat price before any work started, per Clause 1, and the full photo record after we finished.
Opener Replacement on a LiftMaster That Had Seen Better Days in Bixby Knolls
The Bixby Knolls customer’s LiftMaster opener stopped responding to every remote and the wall button on the same day. We tested the logic board and found it was not sending signal to the motor, which on a 14-year-old unit means replacement makes more sense than repair. We installed a new LiftMaster opener with battery backup, new safety sensors, and reprogrammed both remotes. The before photo showed the old board and the worn trolley carriage. The after photo showed the new motor bolted in, the sensors aligned, and the door running smooth with the keypad active.
Track and Cable Repair on a Crooked Door in Naples
A door in Naples was rising crooked and grinding against the track on the left side. The culprit was a bent vertical track and a cable that had started to fray at the drum. We replaced the track section, installed a new cable, and rebalanced the door so it lifted evenly. The before photo caught the angle of the door and the steel strands poking out of the cable. The after photo showed the door sitting square in the opening, both cables taut, and the rollers running without drag. The owner got the before-and-after photo record on the spot.
Weather Seal and Threshold Job in Alamitos Heights
The Alamitos Heights garage floor had a visible line of daylight under the door, and every wind event pushed leaves and dust inside. The old bottom seal was cracked and brittle. We pulled it, installed a new heavy-duty rubber seal, and added a floor threshold where the concrete had settled unevenly. The before photo showed the daylight gap and the cracked material. The after photo showed the seal compressed evenly against the threshold. The difference is in the floor staying clean the next time the wind picks up off Marine Stadium.
Want Results Like These?
Every job above started with a written price before any work began, and ended with a documented photo record in the customer’s hands. That is the standard we have worked to since 2015, and it applies to every repair, replacement, and opener we install in Long Beach. Call (424) 688-6426 and we will name the price in writing before the first tool comes out.
Written by Marcus Deller, Owner at Servo Garage Doors Long Beach, serving Long Beach since 2015.