Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Chamberlain openers
Before
After
Before
After
Before
AfterCraftsman Weather Seal Replacement: The Long Beach Owner’s Guide
We stock and install Craftsman-compatible weather seal replacement in Long Beach, with most jobs running $110-$220 installed depending on door width and seal profile. Our trucks carry the common Craftsman T-style and bulb-style profiles, so most replacements go on the same visit. You usually find out the seal failed the same way every Long Beach homeowner does: a strip of gray rubber hanging off the bottom of the door, or daylight sneaking under the panel when the door’s closed.
Garage door weather seal is the flexible strip attached to the bottom of the door (the bottom seal) and sometimes along the sides and top (the perimeter seal). It’s what keeps rainwater, leaves, dust, and the occasional confused lizard out of your garage. In Long Beach, where salt air works on everything and summer heat bakes the rubber, seals dry out, crack, and compress faster than they do inland. If yours is flaking or sitting uneven, replacement is a fast, inexpensive fix that also cuts the draft into any adjoining room.
Key takeaways:
- Craftsman weather seal replacement in Long Beach typically runs $110-$220 installed.
- Most jobs are same-visit, because we carry the common profiles on the truck.
- You get a written flat price before work begins, per Clause 1 of The Haven Standard.
- Seal failure is not dangerous to live with short-term, but it gets worse every month.
Which Craftsman Models This Applies To
Most Craftsman garage doors made in the last 25 years use a standard T-style bottom seal that slides into a U-channel retainer on the door’s bottom panel. The T-style profile is measured across the two “wings” at the top of the strip, and you’ll see 1/4-inch, 3/8-inch, and 5/16-inch widths depending on the door’s build year. The easiest way to identify yours is to look at the retainer channel itself, not the old rubber: measure the opening the seal slots into, then pick the profile that matches.
For the side and top perimeter seals on older Craftsman doors, the profile is usually a compressible bulb-style strip. It collapses as the door closes against the opening, which is what creates the seal. Over time in Long Beach’s salt air, the bulb loses its spring-back. When it stays compressed, that’s when you get light and airflow at the edges of a properly-aligned door.
One Craftsman-specific compatibility note: some doors built in the early 2000s used a proprietary bottom retainer that is slightly narrower than aftermarket channels. If the new seal fits loose or needs forcing, the retainer itself may need replacement, which stays in the same price range. We carry OEM and quality aftermarket profiles for Craftsman, and if the exact OEM profile is no longer in production, we use an equivalent spec and photograph what went in so you see exactly what you paid for. Servo Garage Doors Long Beach is an independent service provider and not affiliated with Craftsman; we also stock parts for LiftMaster, Chamberlain, and Genie.
Signs Your Craftsman Weather Seal Replacement Is Failing
- The seal drags on the floor when the door opens. This usually means the strip has stretched or partially pulled out of its channel. The loose end catches the concrete and peels more of the seal out every cycle. If you see a folded tab of rubber under the door, that’s the start.
- Daylight visible under the closed door. The seal has compressed to the point where the bottom edge no longer contacts the slab evenly. Long Beach garages are often on slightly settled slabs, so the gap may appear at one corner only. The seal is the adjustment the floor never got.
- Water pooling inside after rain. Bottom seal fails are easiest to spot during the first winter rain: a damp line forms along the inside edge of the door. If water reaches the drywall or an interior door, the seal has been gone for weeks, not days.
- Crumbling, cracking, or chalky rubber. UV and salt air dry out the polymer. Rub the seal with a finger; if it leaves black or gray residue, the rubber has oxidized past its useful life and new seal is the only appropriate fix. There’s no re-seal product that restores sun-damaged EPDM.
- Something’s living in your garage that shouldn’t be. A surprising number of Long Beach calls about “drafty” garages turn out to be vole or mouse traffic beneath a flat-bottom seal. Any gap big enough for daylight is big enough for a body smaller than your thumb.
BeforeAfterReplacement Cost & What’s Included
In Long Beach, Craftsman weather seal replacement runs $110-$220 installed. The range moves on two things: the door’s width (a single-car door is about 9 feet; a two-car door is 16 or 18 feet) and whether you need a bottom seal only, or bottom plus perimeter sides and top. A full perimeter set on a 16-foot door sits at the upper end of that range.
| Job | Typical Range |
|---|---|
| Bottom seal replacement (single door) | $110-$160 |
| Bottom seal replacement (double door) | $150-$220 |
| Bottom + perimeter seals (double door) | $180-$220 |
Every quote is a flat, written price with a written scope given to you before any work begins. Clause 1 of The Haven Standard says it plainly: the unit price is on the page, not behind a phone call. Your quote includes the seal, the old part removal, cleaning the retainer channel, and the installation. Like every job we do, you receive a documented photo record of the failed seal and the new one after install, so the evidence of what was fixed stays in your hands.
The work carries our 365-Day Done Right Promise: if the replacement doesn’t hold up the way it should, we make it right.
DIY or Call Us?
A weather seal is the least dangerous repair on a garage door. There are no springs or cables involved, and you’re working at floor level. If you’re handy and the bottom seal pulls out of the channel easily, a hardware store replacement can be a satisfying Saturday job. That said, what goes wrong in the field is usually the channel, not the rubber. If a previous owner glued, screwed through, or zip-tied the seal into place, digging it out without bending the channel takes longer than the money you’d save.
The parts most people buy off the shelf are also the wrong profile. The seals at big box stores are usually 3/8-inch T-style. If your Craftsman needs a 5/16-inch or a 1/4-inch profile, the new strip will bind or fall out within weeks. If you’re not sure which profile the door takes, call us at (424) 688-6426 and we’ll identify it from a photo before we ever show up.
FAQs
A bottom seal lasts about 4 to 7 years in Long Beach’s salt air and sun exposure, and a perimeter seal usually outlives the bottom strip because it gets less direct UV. Sea-breeze-adjacent homes (Naples, Belmont Shore, the Peninsula) tend to see the shorter end of that range. If yours is flaking or shrinking after four years, it’s on schedule. For an exact look at what’s on your door, call (424) 688-6426 and we’ll talk through what you’re seeing.
Weather seals get replaced, not repaired. The failure is the material itself: once EPDM or vinyl has cracked, compressed, or pulled free, no adhesive or patch restores the seal. The good news is this is one of the least expensive parts on the door. The fix costs less than almost any other garage door repair, and the price range is written above.
Most single-door bottom seal replacements take 30 to 45 minutes. A full perimeter set on a double door runs closer to an hour and a half, mostly from cleaning the side channels. If we’re already at your home for another repair, the seal typically goes on in the same visit. Call (424) 688-6426 and we’ll give you a written price before any work starts.
Yes, we carry the common Craftsman T-style profiles and the bulb-style perimeter seal on every truck. If your door needs a less common profile, we order it and schedule the install once it’s in hand, with the same written price you were quoted before. No surprise invoices, no markup added after the fact.
Get a Written Price for Your Craftsman Weather Seal Replacement in Long Beach
Name the part, quote the range, then do the work - in that order. Call (424) 688-6426 and we’ll identify your seal profile from a photo, give you a flat written price, and book a time that works. Servo Garage Doors Long Beach has been making garage doors right since 2015, with a written price before any work starts and a documented photo record when the technician leaves. If you have a written estimate from another company, bring it - we’ll give you a free second opinion, no coupon required.
Written by Marcus Deller, Owner, Servo Garage Doors Long Beach at Servo Garage Doors Long Beach, serving Long Beach and nearby areas.